Woodworking sliding table saw problem solution

Woodworking sliding table saw problem solution

 

  Sliding table saw problem shooting

1, Sliding table saw can not start

The main switch does not start, the main switch "I", the circuit is interrupted or a phase interrupt, waiting for the circuit to recover, or find out the cause of the power outage, to be excluded, such as a fuse burned.

Overload protection tripping, but the thermal relay has not yet cooled, can not be reset, solve the machine overload problem in time, wait for thermal relay cooling,

The end of the movable table exceeds the middle of the saw blade and the sawing length is not enough. The movable table is pulled back to the front of the middle of the saw blade.

The emergency switch was pressed and the emergency switch turned right and returned to its original position.

The front guard plate of the saw blade or the back door of the machine is not closed. Please close the door and cover the guard plate.

The fuse that manipulates the current circuit is burned out. At this time, the electrical box can be opened (before turning off the main switch) to find out which of the F1, F2, F3 insurance is damaged. Find out the reason, eliminate the fault, and then replace the burned fuse. Note that only the fuse with the same load can be used.

One or more phase power interruptions, such as restarting the machine because the fuse is blown, remove the cause of the phase relay.

Because the blade is too blunt, or the cutting speed is too fast, it causes the overload protection trip, replaces the new blade or reduces the sawing speed, waits for the thermal relay to cool, and then restarts.

The fuses that manipulate the current circuit are damaged, open the electrical box (before closing the main switch), and find out which of the F1, F2, F3 insurance is damaged. Find out the reason, eliminate the fault, and then replace the burned fuse. Note that only the fuse with the same load can be used.

2, the motor is turning, but the work-piece does not go

The saw blade was blunt. The dicing blade and the saw blade did not match. Put a new saw blade and replace it with a suitable sub-blade. The sub-blade thickness was slightly narrower than the main saw blade.

3. The work-piece width after sawing does not match the width adjusted on the parallel baffle, the scale of the sawing width is shifted, the scale is readjusted, a work-piece is sawed on the parallel baffle, the sawing width is measured, and then the sawing width is measured. The scale on the aluminum scale is adjusted to this size.

4, swing arm instability

Telescopic arm or guide wheel is dirty, clean telescopic arm and guide wheel.

5. The active workbench runs off or on the worktable at the end of the worktable, the guide wheel is not properly installed, and the guide wheel of the worktable is adjusted.

6, saw blade burning on both sides

Insufficient sawing adjustment is not enough, the work-piece is stuck, and the operation is wrong. Adjust the free sawing, change the thicker knife, or push the work-piece to the left or forward. Use a movable table to cut, do not rely on parallel baffles.

7. After the sawing of the work-piece has scorch marks, the saw blade may be too blunt and too much saw teeth on the saw blade. At this time, the saw blade may be updated. Free sawing error is to adjust free sawing.

8,Collapse (with a slot saw), the slot saw and the main saw are not in a line, re-centerline adjustment, slotted blade is too narrow, adjust the blade width.

Please feel free to give your inquiry in the form below.
* Subject :
* Email :
  • Name :

  • Phone:

  • *Message :
    Message